| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the access control list (ACL) programming of Cisco IOS XE Software for Cisco Catalyst 9500X and 9600X Series Switches could allow an unauthenticated, remote attacker to bypass a configured ACL on an affected device.
This vulnerability is due to the flooding of traffic from an unlearned MAC address on a switch virtual interface (SVI) that has an egress ACL applied. An attacker could exploit this vulnerability by causing the VLAN to flush its MAC address table. This condition can also occur if the MAC address table is full. A successful exploit could allow the attacker to bypass an egress ACL on an affected device. |
| Multiple Cisco products are affected by a vulnerability in the Snort detection engine that could allow an unauthenticated, remote attacker to bypass a configured file policy for HTTP.
The vulnerability is due to incorrect handling of specific HTTP header parameters. An attacker could exploit this vulnerability by sending crafted HTTP packets through an affected device. A successful exploit could allow the attacker to bypass a configured file policy for HTTP packets and deliver a malicious payload. |
| A vulnerability in the Network-Based Application Recognition (NBAR) feature of Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to reload, causing a denial of service (DoS) condition.
This vulnerability is due to improper handling of malformed Control and Provisioning of Wireless Access Points (CAPWAP) packets. An attacker could exploit this vulnerability by sending malformed CAPWAP packets through an affected device. A successful exploit could allow the attacker to cause the device to reload unexpectedly, resulting in a DoS condition. |
| A vulnerability in Cisco IOS XE Software could allow an authenticated, local attacker with level-15 privileges or an unauthenticated attacker with physical access to an affected device to execute persistent code at boot time and break the chain of trust. This vulnerability is due to improper validation of software packages. An attacker could exploit this vulnerability by placing a crafted file into a specific location on an affected device. A successful exploit could allow the attacker to execute persistent code on the underlying operating system. Because this vulnerability allows an attacker to bypass a major security feature of a device, Cisco has raised the Security Impact Rating (SIR) of this advisory from Medium to High. |
| A vulnerability in the Simple Network Management Protocol (SNMP) subsystem of Cisco IOS XE Software could allow an authenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to improper error handling when parsing a specific SNMP request. An attacker could exploit this vulnerability by sending a specific SNMP request to an affected device. A successful exploit could allow the attacker to cause the device to reload unexpectedly, resulting in a DoS condition.
This vulnerability affects SNMP versions 1, 2c, and 3. To exploit this vulnerability through SNMPv2c or earlier, the attacker must know a valid read-write or read-only SNMP community string for the affected system. To exploit this vulnerability through SNMPv3, the attacker must have valid SNMP user credentials for the affected system. |
| Multiple vulnerabilities in Cisco IOS XE Software of could allow an authenticated, local attacker with level-15 privileges or an unauthenticated attacker with physical access to the device to execute persistent code at boot time and break the chain of trust.
These vulnerabilities are due path traversal and improper image integrity validation. A successful exploit could allow the attacker to execute persistent code on the underlying operating system.
Because this allows the attacker to bypass a major security feature of the device, Cisco has raised the Security Impact Rating (SIR) of this advisory from Medium to High.
For more information about these vulnerabilities, see the Details ["#details"] section of this advisory.
ERP |
| A vulnerability in the handling of certain Ethernet frames in Cisco IOS XE Software for Catalyst 9000 Series Switches could allow an unauthenticated, adjacent attacker to cause an egress port to become blocked and drop all outbound traffic.
This vulnerability is due to improper handling of crafted Ethernet frames. An attacker could exploit this vulnerability by sending crafted Ethernet frames through an affected switch. A successful exploit could allow the attacker to cause the egress port to which the crafted frame is forwarded to start dropping all frames, resulting in a denial of service (DoS) condition. |
| A vulnerability in the Geolocation-Based Remote Access (RA) VPN feature of Cisco Secure Firewall Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass configured policies to allow or deny HTTP connections based on a country or region.
This vulnerability exists because the URL string is not fully parsed. An attacker could exploit this vulnerability by sending a crafted HTTP connection through the targeted device. A successful exploit could allow the attacker to bypass configured policies and gain access to a network where the connection should have been denied. |
| A vulnerability in the Day One setup process of Cisco IOS XE Software for Catalyst 9800 Series Wireless Controllers for Cloud (9800-CL) could allow an unauthenticated, remote attacker to access the public-key infrastructure (PKI) server that is running on an affected device.
This vulnerability is due to incomplete cleanup upon completion of the Day One setup process. An attacker could exploit this vulnerability by sending Simple Certificate Enrollment Protocol (SCEP) requests to an affected device. A successful exploit could allow the attacker to request a certificate from the virtual wireless controller and then use the acquired certificate to join an attacker-controlled device to the virtual wireless controller. |
| A vulnerability in the implementation of the TACACS+ protocol in Cisco IOS Software and Cisco IOS XE Software could allow an unauthenticated, remote attacker to view sensitive data or bypass authentication.
This vulnerability exists because the system does not properly check whether the required TACACS+ shared secret is configured. A machine-in-the-middle attacker could exploit this vulnerability by intercepting and reading unencrypted TACACS+ messages or impersonating the TACACS+ server and falsely accepting arbitrary authentication requests. A successful exploit could allow the attacker to view sensitive information in a TACACS+ message or bypass authentication and gain access to the affected device. |
| A vulnerability in the Internet Key Exchange Version 2 (IKEv2) module of Cisco Secure Firewall Adaptive Security Appliance (ASA) Software and Secure Firewall Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a memory leak, resulting in a denial of service (DoS) condition.
This vulnerability is due to improper parsing of IKEv2 packets. An attacker could exploit this vulnerability by sending a continuous stream of crafted IKEv2 packets to an affected device. A successful exploit could allow the attacker to partially exhaust system memory, causing system instability like being unable to establish new IKEv2 VPN sessions. A manual reboot of the device is required to recover from this condition. |
| A vulnerability in the CLI of Cisco IOS Software and Cisco IOS XE Software could allow an authenticated, local attacker to cause an affected device to reload unexpectedly, resulting in a denial of service (DoS) condition.
This vulnerability is due to a buffer overflow. An attacker with a low-privileged account could exploit this vulnerability by using crafted commands at the CLI prompt. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition. |
| A vulnerability in the Remote Access SSL VPN service for Cisco Secure Firewall Adaptive Security Appliance (ASA) Software and Cisco Secure Firewall Threat Defense (FTD) Software could allow a remote attacker that is authenticated as a VPN user to cause the device to reload unexpectedly, resulting in a denial of service (DoS) condition.
This vulnerability is due to incomplete error checking when parsing an HTTP header field value. An attacker could exploit this vulnerability by sending a crafted HTTP request to a targeted Remote Access SSL VPN service on an affected device. A successful exploit could allow the attacker to cause a DoS condition, which would cause the affected device to reload. |
| A vulnerability in the packet inspection functionality of the Snort 3 Detection Engine of Cisco Secure Firewall Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to incorrect processing of traffic that is inspected by an affected device. An attacker could exploit this vulnerability by sending crafted traffic through the affected device. A successful exploit could allow the attacker to cause the affected device to enter an infinite loop while inspecting traffic, resulting in a DoS condition. The system watchdog will restart the Snort process automatically. |
| A vulnerability in the Internet Key Exchange Version 2 (IKEv2) feature of Cisco IOS Software, IOS XE Software, Secure Firewall Adaptive Security Appliance (ASA) Software, and Secure Firewall Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a memory leak, resulting in a denial of service (DoS) condition.
This vulnerability is due to a lack of proper processing of IKEv2 packets. An attacker could exploit this vulnerability by sending crafted IKEv2 packets to an affected device. In the case of Cisco IOS and IOS XE Software, a successful exploit could allow the attacker to cause the device to reload unexpectedly. In the case of Cisco ASA and FTD Software, a successful exploit could allow the attacker to partially exhaust system memory, causing system instability such as being unable to establish new IKEv2 VPN sessions. A manual reboot of the device is required to recover from this condition. |
| A vulnerability in the management and VPN web servers of the Remote Access SSL VPN feature of Cisco Secure Firewall ASA Software and Secure FTD Software could allow an unauthenticated, remote attacker to cause the device to unexpectedly stop responding, resulting in a DoS condition.
This vulnerability is due to ineffective validation of user-supplied input during the Remote Access SSL VPN authentication process. An attacker could exploit this vulnerability by sending a crafted request to the VPN service on an affected device. A successful exploit could allow the attacker to cause a DoS condition where the device stops responding to Remote Access SSL VPN authentication requests. |
| A vulnerability in the certificate processing of Cisco Secure Firewall Adaptive Security Appliance (ASA) Software and Cisco Secure Firewall Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause the device to reload unexpectedly, resulting in a denial of service (DoS) condition.
This vulnerability is due to improper parsing of SSL/TLS certificates. An attacker could exploit this vulnerability by sending crafted DNS packets that match a static Network Address Translation (NAT) rule with DNS inspection enabled through an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. |
| A vulnerability in the management and VPN web servers of Cisco Secure Firewall ASA Software and Secure FTD Software could allow an unauthenticated, remote attacker to cause the device to reload unexpectedly, resulting in a DoS condition.
This vulnerability is due to improper validation of user-supplied input on an interface with VPN web services. An attacker could exploit this vulnerability by sending crafted HTTP requests to a targeted web server on an affected device. A successful exploit could allow the attacker to cause a DoS condition when the device reloads. |
| A vulnerability in the API endpoints of Cisco Integrated Management Controller could allow an authenticated, remote attacker to bypass authorization and take actions on a vulnerable system without authorization.
The vulnerability is due to improper authorization checks on API endpoints. An attacker could exploit this vulnerability by sending malicious requests to an API endpoint. An exploit could allow the attacker to download files from or modify limited configuration options on the affected system.There are no workarounds that address this vulnerability. |
| A vulnerability in Cisco NX-OS Software could allow an authenticated, local attacker with privileges to access the Bash shell to execute arbitrary code as root on an affected device.
This vulnerability is due to insufficient security restrictions when executing commands from the Bash shell. An attacker with privileges to access the Bash shell could exploit this vulnerability by executing a specific crafted command on the underlying operating system. A successful exploit could allow the attacker to execute arbitrary code with the privileges of root. |
